Abstract
An ultrasonic nanocrystal surface modification (UNSM) technique was applied to a 1-mm thick AZ31 magnesium sheet. UNSM is a relatively new surface modification technique in which a hard, hemispherical tip (2.38 mm in diameter) strikes the surface at an ultrasonic frequency to induce plastically deformed gradient microstructures and deep compressive..... More

Abstract
In this study, Ti-10Mo alloy powder and sintered bodies were successfully fabricated using a threestep process of acid/organic solvent cleaning, hydrogenation/dehydrogenation (HDH) of bulk Ti-Mo scrap, and pressureless vacuum sintering of the alloy powder. This process can be used to recycle valuable Ti alloy. And unlike remelting-based recycling processes, in..... More

Abstract
The demand for palladium (Pd) has increased and this has made it necessary to recover pure Pd from diverse secondary resources. To recover the small amount of Pd(II) present in spent electroplating solutions, Pd(II) is concentrated by cementation with zinc metal. In this work, a hydrometallurgical process consisting of leaching..... More

Abstract
In this study, we demonstrate high-performance optical wavelength-selective organic thin-film transistors (TFTs) that incorporate heterogeneous organic semiconductor materials, poly(3-hexylthiophene) (P3HT) and 6,13-bis(triisopropylsilylethynyl) pentacene (TIPS-pentacene). The electrical characteristics of the fabricated transistors were analyzed in the dark to determine how the P3HT:TIPS-pentacene ratio of the semiconductor affected the performance of the..... More

Abstract
Graphene has been used in various fields because of its excellent mechanical, optical, electrical, and thermal properties. However, its intrinsic low sensitivity to pressure limits its sensor applications. To overcome this drawback, many researchers have tried to improve the sensitivity by controlling the defects on the graphene, but have yet..... More

Abstract
Half-Heusler (HH) thermoelectric materials are promising for mid- to high-temperature applications, and MNiSn (M = Ti, Zr, Hf) is a representative n-type HH alloy. In general, the M sites are mixed with isoelectronic elements Ti, Zr, and Hf, to lower the lattice thermal conductivity, and the Sn sites are doped..... More

Abstract
Advanced electronic materials have attracted great interest for their potential use in flexible, large-area, and printable electronic applications. However, fabricating high-performance low-voltage thin-film transistors (TFTs) for those applications with these advanced semiconductors is still challenging because of a lack of dielectric materials which satisfy both the required electrical and physical..... More

Abstract
WC-Co cemented carbide has excellent mechanical properties and is widely used in many industrial applications including cold forging die and cutting tools. WC-Co cemented carbide is manufactured by liquid phase sintering (LPS), and a new sintering process for densification has been developed. In this study, cylindrical rod shaped tensile and..... More

Abstract
Recent studies have extensively studied the use of composites of carbon nanotubes (CNTs) dispersed in epoxy resin to mechanically reinforce hydrogen storage and lightweight vehicle applications. The mechanical properties of the composite are strengthened due to load transfer from the epoxy matrix to the CNTs when an external force is..... More

Abstract
Magnesium silicate is a porous material with a large specific surface area and is easily adsorbed. In particular, it is widely used commercially because it is very effective for adsorbing Na+, K+ ions and other catalysts. However, if the powder is used as an adsorbent as is, there are disadvantages,..... More