Abstract
In this study, the effects of rolling temperature on the microstructural characteristics of a highspeed-rolled Mg alloy with a non-basal texture were investigated. To this end, commercial AZ31 alloy samples in which the basal poles of most grains were tilted at an angle of 45° from the normal direction (ND)..... More

Abstract
In this work, the angular distribution of the sputtered Cu flux in a long throw sputtering (LTS) system is extracted from the comparison of experimentally-measured profiles of deposited films with simulated profiles of films in overhang contact structure. And effects of the sputtering process parameters such as Ar pressure during..... More

Abstract
The behaviour and performance of complex metallic materials (e.g., advanced high strength steel and dual phase Ti alloys) are acknowledged to be multi-scale in nature and to rely on the details of the threedimensional morphology, chemistry and crystallography at the meso-scale level and on macro-scale level geometry and boundary and..... More

Abstract
Hot stamping is the most efficient manufacturing process to produce high strength automotive parts with reduced springback. Recently, 30MnB5 steel has been developed for hot stamping steel which can provide above 1700 MPa. However, resistance spot weldability of this steel is insufficient due to the need for a large amount..... More

Abstract
In the present study, the correlation of microstructural factors with yield ratio and uniform elongation was investigated in API X80 linepipe steels with different microstructures by varying thermomechanical control process conditions. The grain size and microstructure fraction of the API X80 linepipe steels were quantitatively measured by EBSD analysis and then..... More

Abstract
Recently developed ultra-strong GIGA STEEL exhibites superior mechanical properties, with a high tensile strength of more than 1.5 GPa and good impact toughness. Nevertheless, its application to auto parts has been severely restricted, mainly due to a substantial reduction in the resistance to hydrogen embrittlement (HE) induced by aqueous corrosion...... More

Abstract
AISI M4 and CPM15V are used as tool steels since they have high hardness and wear resistance. This study is concerned with die and mold hardfacing using laser melting deposition with M4 and CPM15V powders. For this purpose, the two types of metal powders were deposited on SKD11 base metal,..... More

Abstract
This study was conducted to obtain engineering design data for a process to recover lithium in the form of Li₃PO₄ from the waste water of a lithium ion battery (LIB) recycling process. The influence of temperature, pH, and concentration on the solubility of Li₃PO₄ and the reaction rate in the..... More

Abstract
Severe resistivity size effect in Cu interconnects is attributed to the relatively long bulk electron mean free path (39 nm at 298 K), which is inherently determined by phonon scattering. In this regard, Ru and Co have been recently considered as attractive alternatives for next-generation interconnect materials because the significantly..... More